azrael2000
Technical User
Hi All.
I'm trying to configure putty to do smdr collection on the NS700.
My current settings are:
IP Address : x.x.x.x
Port 2300
Speed 9600,9600
Port under smdr tab is : LAN(TELNET)
Incoming / outgoing are set to print.
When I open the configuration I see SMDR, and enter the password - currently default.
It sits there, but when I make a call, I don't see anything print out, and after a little bit, putty closes.
Any ideas?
Regards
I'm trying to configure putty to do smdr collection on the NS700.
My current settings are:
IP Address : x.x.x.x
Port 2300
Speed 9600,9600
Port under smdr tab is : LAN(TELNET)
Incoming / outgoing are set to print.
When I open the configuration I see SMDR, and enter the password - currently default.
It sits there, but when I make a call, I don't see anything print out, and after a little bit, putty closes.
Any ideas?
Regards