jefferyzhong
MIS
I try to populate some information from a combo box, but I can not find the combo box wizard, can anyone tell me how? and is there another way to populate data without wizard?
thanks
thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
combo box wizard
- Thread starter jefferyzhong
- Start date
- Status
The wizard runs when you create a new combo box, while the 'Use Wizards' button in the Toolbox is depressed.
'Use Wizards' is the button at the top right of the toolbox (in Access 2000) which has a 'magic wand' symbol on it. If you hover the mouse over this button, the Tool Tip says 'Control Wizards'.
Click this button, and make sure it is in the 'depressed' position, then create your combo box. The wizard will then run for you.
Bob Stubbs (London, UK)
'Use Wizards' is the button at the top right of the toolbox (in Access 2000) which has a 'magic wand' symbol on it. If you hover the mouse over this button, the Tool Tip says 'Control Wizards'.
Click this button, and make sure it is in the 'depressed' position, then create your combo box. The wizard will then run for you.
Bob Stubbs (London, UK)
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question