I have a 81 and 11 tied together with Tie lines and am confused about clocking between the two. Do I need a clock controller in the 11 and what do I set up in the DDB as far as clocking for the 11? I need the 11 to clock off the 81.
Thanks for the help
I changed out the Clock controller and when I do ssck 0 I get a DTI061 and Tracking ERR I can put into FRUN and I get no errors. When I bring up loop on the 81 I get a DCH relaese No Response.Loop on 81 is 21 loop on 11 is 1
myarberry...you said you are getting dch release are
you programmed as a plain t1 not a pri which has a
d-channel.are you going thru a telco or going thru
your own cable plant.if a local telco is involved
how is it provisioned.
I am using a Cross Over cable I know that the Clock is enabled. When tracking on Primary CC light flashes,When I put in Free Run CC light steady but D channels start to go up and down.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.