Clock light blinks fast and is green

[Ponyboy13]

I have a UDT with a clock card and the CC light blinks fast but i'm not seeing any errors in the system or on the counters. Any ideas why it blinks fast?

 

[Ponyboy13]

I should say its a Nortel 1000e and we are using an OPT 11 cabinet as a gateway whit several UDT cards.

 

[bignose21]

Usually blinking means its not locked to a source. LD 60
Ssck loop shelf
Trck pck loop shelf

 

[Ponyboy13]

It shows to be tracking on the loop that has the blinking green light.

 

[KCFLHRC]

Disable the clock and enable it, I have seen this before. You may actually have to disable the card and re seat it.

 

[Ponyboy13]

I did disable and enable the clocks at one point and will reseat the UDT when they will let me. Thanks

 

[Tman45]

Yep we had an issue where our secondary core was trying to take over clocking of the primary so all of our clock controllers were flashing green for about 7 blinks and then would go solid. Everytime I could catch them flashing it would say free run/tracking. I reported this and the vendor told me to 'Stop watching the lights and go watch TV' - needless to say they no longer install/maintain systems ... I could give you a hint on who but I don't think it is allowed - haha

But yes, your issue is definitely related to tracking ...

 

[I2007]

Hi,

Just make sure you have the latest loadware installed on the UDT card. There are a lot of fixes during the last 2 years on those cards, and new cards are shipped with older loadwares.

LD60
.ver <loop>
(it has to be enabled)

The latest loadware should be udtcab17 I think.

I2007