Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CLAN speed
- Thread starter SoDoTo
- Start date
Callmaster
Technical User
i check the speed with the "trace route" option.
type trace route ip-address ...
With best regards
Callmaster
type trace route ip-address ...
With best regards
Callmaster
henningwentzel
Technical User
what version of ACM?
on the CM 2 you will cha the ip-interface XXXXX
and change the negotion from auto-neg to whatever you want
10M full/half or 100M full/half
on the CM 2 you will cha the ip-interface XXXXX
and change the negotion from auto-neg to whatever you want
10M full/half or 100M full/half
TN799C and lower suffix boards only work at 10/half. The TN799D can be configured. In later version switches you can do 'display ethernet' and it will show you the current speed & duplex setting for all of the IP boards installed. 'get ethernet <slot>' will show you what is administered vs. what is running.
Kevin
Kevin
BurningChr0me
MIS
The CLAN should be locked do to 100/Full and so should the network port this way u can avoid packet collisions and having the CLAN lock up.
Beginning in V10 you can set the speed on the TN799D boards. You can do a 'display ethernet' to see the configuration of the C-LAN, MedPro, and VAL boards. The TN799C boards only run at 10/half. In switches prior to V10 all C-LAN boards must be configured in the IP network for 10/half.
Kevin
Kevin
- Status