emuldoon66
Programmer
I have a Definity G3si V11 that I integrated directly with a new Intuity Audix MAP5 R5 via the CLAN. All indications are that the link is good. The Intuity Switch Link Status screen shows the Link to be up and running. The Definity 'status link 1' command shows the link connected, inservice/active, enabled, with active channels 1. I can ping in both directions, so they appear to be properly integrated. However, I can't get the Audix to recognize digits without physically dialing them in. I get the same standard greeting asking me to dial the extension of the person I want to leave a message for. I have created a subscriber with the extension number of the station I am calling. The voice channels have the DNIS service assigned, I added my Definity extension ranges to the Number Services on the voice channels, and even assigned the corresponding PBX Extenions to each voice channel. I created vmail stations on the Definity, placed them in a hunt group, assigned the hunt group to a coverage path, and assigned the coverage path to the station. If I hadn't already cut it off, I'd be pulling my hair out on this one. Thanks for any input you can supply.