KoronaAxe02
Vendor
- Jul 10, 2008
- 6
I have 2 Cisco 2610 routers with the password recovery disabled. I've tried all the solutions Cisco's website has offered, or that I could find. Here is the link I found:
When I send the break command after I see "Image text-base", I answer the prompts but it doesn't reset the unit to the factory defaults....both routers go straight back to being password protected with no Rommon access. Am I screwed? or is there another way around this?
I'm most likely going to return these units anyway for reasons other than the recovery problem, but I'd still like to know if anyone can help...just in case they won't take the units back and for future reference. Thanks for reading, any help would be greatly appreciated!
When I send the break command after I see "Image text-base", I answer the prompts but it doesn't reset the unit to the factory defaults....both routers go straight back to being password protected with no Rommon access. Am I screwed? or is there another way around this?
I'm most likely going to return these units anyway for reasons other than the recovery problem, but I'd still like to know if anyone can help...just in case they won't take the units back and for future reference. Thanks for reading, any help would be greatly appreciated!