Thanks Joamon.
So I take it the cisco isn't able to negotiate? Do you know if any of these 2610's weren't able to run at full duplex or is half the standard configuration? I didn't do the setup.
Half is the standard. Clear counters before you change it and then do a show interface and check it a couple of times for errors. In half duplex you will see collisions (normal) and when in full duplex collisions should go away but you dont want to see CRC or other errors. This router is kind of touch and go when not connected to a managed switch set to same settings. I have had problems when connected to unmanaged auto-negotiating switches.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.