CIL NIU2

[gosad]

hello

I use md110 bc11 and i try run cil on niu2 rs232.
My ioddp;
<IODDP;
I/O DEVICE DATA
NODE IODEV/SUBFS BPOS/EQU I/O-BUS TYPE/USAGE STATUS AUTH
SYSN - 001-0-50 - - IN SERVICE
SYSN SYSDISK1 001-0-50-0 MASTER TOSHIBA IN SERVICE
SYSSUBFS11
SYSSUBFS21
SYSN SYSTERMINAL 001-0-50-1 - MML - 7
SYSN MML2 001-0-50-2 - MML - 7
SYSN CIL-1 001-0-50-3 - OUT IN SERVICE
SYSN CILNET 001-0-50-4 - NETWORK/OUT IN SERVICE
SYSN MMLETH 001-0-50-4 - NETWORK/MML - 7
SYSN MMLETH2 001-0-50-4 - NETWORK/MML - 7
END

if i enter
CLDFI:FILE=CIL,IODEV=CIL-1,USER=CIL-1;
NOT ACCEPTED
NIU
NOT ALLOWED

I try USER=NONE and cil nertwork connected answer is same always
NOT ACCEPTED
NIU
NOT ALLOWED

If you have any idea what to check on this problem, please write !

Thanks
I'am new on this forum and sory fo my english

 

[Monrovia]

CLFDI:IODEV=SMDR,FILE=SMDR,USER=CIL1;

i hope this will work

 

[gosad]

CLDFI:IODEV=SMDR,FILE=SMDR,USER=CIL1;
NOT ACCEPTED
USER
NOT IN RANGE

After change of user

CLDFI:IODEV=SMDR,FILE=SMDR,USER=CIL-1;
NOT ACCEPTED
NIU
NOT ALLOWED

CLDFI:IODEV=SMDR,FILE=SMDR,USER=NONE;
NOT ACCEPTED
NIU
NOT ALLOWED

any idea

 

[mdman]

Do you have CIL on SIU active in your system?

You cannot run CIL on SIU and on NIU in one system.

 

[whosrdaddy]

please print current status:

CLDFP;
EDEQP;
CLINP;

/Daddy

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[gosad]

print result

<CLDFP;
FILE ADMINISTRATION DATA
END

<EDEQP;
NOT ACCEPTED
DEV
NOT INITIATED
<CLINP;
CALL LOGGING DATA
CALL LOGGING MODE: NOT ACTIVATED
MOBILITY LOGGING MODE: NOT ACTIVATED
HEADER FORM DMPSIZ DISCR IN SERVICE LOGABN HRTBT
CIL 2 1 0 YES NO NO
ORIG DIAL TIME
ALL 0 ALL
ALL 199 ALL
ALL 198 ALL
ALL 197 ALL
ALL 196 ALL
ALL 191 ALL
ALL 890 ALL
DIR LIM BPOS EVENT


END

I was have card SIU bad it broken and fing i was remov it on system.

 

[Satellite1900]

Try sconfigurare fully cyl including the door on NIU.
And this re-configuration ...
IOEQI:IODEV=ACAB,EQU=1-0-50-3,USAGE=OUT;
CLDFI:FILE=CAB,USER=NONE,IODEV=ACAB,PRIO=C;
CLOHI:FILE=CAB,FORM=2,DMPSIZ=1,DISCR=0,LOGABN=N0,LOGFAL=0;
CLODI:FILE=CAB;
CLODI:FILE=CAB,DIAL=0;
CLTGI;

 

[gosad]

I have checked way it and I search solution

<IOEQI:IODEV=ACAB,EQU=1-0-50-3,USAGE=OUT;
EXECUTED

<CLDFI:FILE=CAB,USER=NONE,IODEV=ACAB,PRIO=C;
NOT ACCEPTED
NIU
NOT ALLOWED

 

[whosrdaddy]

please give the printout of LIDAP;

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[gosad]

<lidap;

EIC=01-3688
SEQUENCE ID=3

PORT LICENCES

LICENCE TAG FAL ALLOWED USED
ACD-AGENT FAL104525 10 0
ANALOGUE-EXTENSION FAL104451 480 349
ANALOGUE-EXTENSION-CLIP FAL1046191 0 0
ANCD-V24-INTERFACE FAL104526 2 0
APP-LINK-INTERFACE FAL104536 0 0
BASE-STATION-DECT FAL104520 0 0
CAS-EXTENSION FAL104455 0 0
CCM-ETH-INTERFACE FAL104531 0 0
CCM-V24-INTERFACE FAL104530 1 0
CIL-HDU-INTERFACE FAL104710 0 0
CORDLESS-EXTENSION FAL104454 0 0
CTT-EXTENSION FAL104457 0 0
DIGITAL-EXTENSION FAL104452 472 449
DTMF-RECEIVER-MOB-EXT FAL1043610 0 0
DUPLICATED-CS FAL104491 0 0
EM-ETH-INTERFACE FAL104538 0 0
EM-V24-INTERFACE FAL104537 2 0
EXTERNAL-LINE-APNSS FAL104467 0 0
EXTERNAL-LINE-CAS-ANA FAL104461 218 28
EXTERNAL-LINE-CAS-DIG FAL104462 0 0
EXTERNAL-LINE-CCSS7 FAL104705 0 0
EXTERNAL-LINE-DASS FAL104463 0 0
EXTERNAL-LINE-DPNSS FAL104465 0 0
EXTERNAL-LINE-H323 FAL1042179 0 0
EXTERNAL-LINE-H323-SERV FAL1043611 0 0
EXTERNAL-LINE-ISDN-NET FAL104507 30 0
EXTERNAL-LINE-ISDN-USR FAL104464 210 90
EXTERNAL-LINE-QSIG FAL104466 0 0
FIXED-REMOTE-EXTENSION FAL1040524 0 0
FREESEATING FAL1040050 0 0
GENERIC-EXT-SMS FAL104708 0 0
GROUP-SWITCH-LINK FAL104492 9 7
IP-EXTENSION FAL104706 0 0
IS-ETH-INTERFACE FAL104533 0 0
IS-V24-INTERFACE FAL104532 1 0
ISDN-TERMINAL-INTERFACE FAL104453 0 0
LINE-INTERFACE-MODULE FAL1040049 5 3
MOBILE-EXTENSION FAL1040525 0 0
OM-ETH-INTERFACE FAL104540 3 2
OM-V24-INTERFACE FAL104539 4 1
OPERATOR-EXTENSION FAL104456 4 3
PAGING-LOOP FAL104518 8 0
PAGING-PARALLEL FAL104519 8 0
PAGING-SERIAL FAL104517 8 0
PERSONAL-NUMBER-USER FAL104472 0 0
RADIO-EXTENSION FAL1040285 0 0
REPEAT-IND-DIV-USER FAL104471 0 0
RVA-EXTERNAL FAL104487 12 0
RVA-INTERNAL FAL104486 12 0
SMDR-ETH-INTERFACE FAL104489 0 0
SMDR-V24-INTERFACE FAL104488 5 0
VCU-FAX-III-PORT FAL104512 12 0
VM-ETH-INTERFACE FAL104535 0 0
VM-V24-INTERFACE FAL104534 3 0
VOICE-MAILBOX FAL104470 0 0
VOICE-PORT FAL104547 0 0
VOICE-SYSTEM FAL104546 0 0
VOIP-ETH-INTERFACE FAL104707 0 0

SYSTEM LICENCES

LICENCE TAG FAL ALLOWED
A-NUMBER-DISPLAY-ATS FAL1041997 NO
ANCD-FEATURE FAL104545 YES
DISA-NUMBER FAL104484 YES
DUPLICATED-GS FAL104524 NO
HOSPITALITY-APPLICATION FAL104709 NO
NET-SERVICES FAL104506 YES
ORIGINAL-A-NUMBER FAL1040278 NO
QSIG-CALL-OFFER FAL1041985 NO
ROUTING-SERVER-CLIENT FAL1046193 NO
ROUTING-SERVER-SERVER FAL1046192 NO
TRAFFIC-MEASUREMENT FAL104485 YES
END

 

[Satellite1900]

Analyze the possibility of restart the follow unit program:
CLOM
CLP
NIP
TWP3

 

[gosad]

I restarted the program without results .

 

[kank]

did you tried to delete all related call logging definations? Like:
CLTGE;
CLODE:FILE=CIL;
CLOHE:FILE=CIL;
CLDFE:FILE=CIL,USER=XXX;
IOEQE:IODEV=XXXX; and
IOEQI:IODEV=ACAB,EQU=1-0-50-3,USAGE=OUT;
CLDFI:FILE=CAB,USER=NONE,IODEV=ACAB,PRIO=C;
CLOHI:FILE=CAB,FORM=2,DMPSIZ=1,DISCR=0,LOGABN=N0,LOGFAL=0;
CLODI:FILE=CAB;
CLODI:FILE=CAB,DIAL=0;
CLTGI;

 

[gosad]

Thanks for assistance it work ok .
Formerly i wasn't erase all call criteria.

 

[albus75]

you need the CIL-HDU-INTERFACE FAL104710 0 0