Change signaling E&M

[jion85]

Hi ia have aproblem I tried to connect the md110 bc9 with E1 card to my Cisco E1
and the calls cut And I though can be the signaling because E&M inthe MD110 is V an d the cisco uses I the person to manage the MD 110 tellme that he can´t change the signaling and in teh cisco i can´t too
Someone has an answer about this???

Thanks in advanced

 

[Radoje]

Put some more information:
Type of CISCO
IOS (software version) of CISCO
Interface type on CISCO
What board you use in MD110

 

[jion85]

Hi this is the information from the cisco but md110 i don´t know th e board
but that I know that the md110 was installed 11 years ago

I change the ciso for 3640 and the problem persist
Do you think the processor o Memery can be the problem???




FUTURAMA-CENTRAL uptime is 1 day, 15 hours, 49 minutes
System returned to ROM by reload
System image file is "flash:c3725-is-mz.122-8.T5.bin"

cisco 3725 (R7000) processor (revision 0.1) with 111616K/19456K bytes of memory.
Processor board ID JMX0647L41F
R7000 CPU at 240Mhz, Implementation 39, Rev 3.3, 256KB L2 Cache
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
3 Channelized E1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
55K bytes of non-volatile configuration memory.
31296K bytes of ATA System CompactFlash (Read/Write)