CDR Recording

[nick1977]

My psychotic Hipath 4K has decided to drop the 192 in front of the 0.0.2.55? Does anyone know the command to change it back to 192.0.2.55 from expert mode?

Best Regards,
Nick


DISPLAY COMPLETED;
<dis-lssm;
DIS-LSSM;
H500: AMO LSSM STARTED

+=========================================================================+
| STATE OF LAN - CHANNELS |
+=========================================================================+
| | | SYSTEM | USER |
| TCP- | STATE |=========================================================|
| LINE | | IP ADRESS | PORT | IP ADRESS | PORT |
+=========================================================================+
| 1 | ON | 192.0.2.3 | 1201 | [highlight #FCE94F]0.0.2.55[/highlight] | 0 |
| 2 | ON | 192.0.2.3 | 1202 | 0.0.0.0 | 0 |
| 3 | OFF | 0.0.0.0 | 0 | 0.0.0.0 | 0 |
| 4 | OFF | 0.0.0.0 | 0 | 0.0.0.0 | 0 |
| 5 | OFF | 0.0.0.0 | 0 | 0.0.0.0 | 0 |
| 6 | OFF | 0.0.0.0 | 0 | 0.0.0.0 | 0 |
+=========================================================================+

 

[sbcsu]

The IP address you have highlighted is the IP of the PC/Laptop that is connected to the HiPath
Check again the IP address that has been set there 'IPCONFIG /all'

 

[nick1977]

The ip address of the CDR machine is 192.0.2.55. I haven't changed it. It appeared to stop working about 1:00 am last night.

Best Regards,
Nick

 

[sbcsu]

Yes but the CDR machine should be collecting the calls on port 1202 (LINE 2)
Port 1201 is for getting the system errors out in real time
Change the port on your CDR to 1202 and ACT-LSSM:A1,2;

 

[nick1977]

Thank you again SBCSU. Your help is priceless.

Nick

 

[RonnieDio1]

Can CDR port other than eth0 via LSSM.

thanks

 

[sbcsu]

CDR port is normally 1202 FROM the HiPath
CDR port being used on the CDR Server is any port it decides.