I am not able to configure a catalyst 1900 switch
I am using a cisco rollover cable connecting thru hyperterminal. I only get ATQ prompts from screen. I am using 9600,N,8,1
I am using the same rj45 db9 female connectors and rollover cable that I configure my 2500 series router with, and I have no trouble, so it's something about the switch.
When I pushed & held in the mode button and turnon the router I got the ethernet address and the Operation firmware level of 5.37. Do I have do upgrade this inorder to use console port, Please advise
thanks
Jim3725
I am using a cisco rollover cable connecting thru hyperterminal. I only get ATQ prompts from screen. I am using 9600,N,8,1
I am using the same rj45 db9 female connectors and rollover cable that I configure my 2500 series router with, and I have no trouble, so it's something about the switch.
When I pushed & held in the mode button and turnon the router I got the ethernet address and the Operation firmware level of 5.37. Do I have do upgrade this inorder to use console port, Please advise
thanks
Jim3725