CAS R2 on BP250

[tarikou]

Hi everybody

I need to connect a BP250 to the local provider through a CAS R2 link (30 digital CAS chanels but not ISDN); I've tried many options with no success. The problem is that on incoming calls I see the 2 leds on the BTU-D board lightning green but the call is not received on the phone.
Same problem on outgoing, when I take the CAS trunk I see the green leds lightning on the board but the call is rejected.
For info the Link supervior says that the link is OK (20)

Did somebody knows how to set the principal commands as:
- 1901: CRC-4 alarm condition.
- 1023: Trunk Line type.
- 1202 Line signal scheme.
- 1301/02: Incoming/Outgoing digit Transmision.
- 1317: Complete called party number length.
- Monitoring times for outgoing traffic parameters.
- 1312: MFC Signal scheme.

And other parameters if I missed some ones.

Thanks a lot in advance.

 

[tarikou]

Hi again everybody

It seems like I found where is the probleme, but I don't know how to fix it.
As the provider made a trace of a call, it looks like I do not send the clip, anybody knows where can I program the sending of Clip (identification).


Thanks again

 

[aastratech]

Tarikou,

enable cmd 1915 and 1918 see if that helps

 

[tarikou]

Hi Mdevo

Unfortunatly on BTU-D bords for CAS there is no 1915 & 1918 cmd, there are only on RNIS.

Thanks