Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cant share files over wireless network with Cisco 1812w

Status
Not open for further replies.

MrOyvind

Technical User
Aug 10, 2007
99
NO
Hi

I can't share files over the integrated AP in the Cisco 1812w router. Using the same SSID and subnet. What Cisco feature is used to unlock this ? No additional security are applied to dot11 radio interface.

ip dhcp pool POOL_90
import all
network 192.168.90.128 255.255.255.128
default-router 192.168.90.129
dns-server xxxxxx
netbios-node-type h-node

dot11 ssid yourhouse
authentication open
authentication key-management wpa
guest-mode
wpa-psk ascii 7 xxxxxxxxx

interface Dot11Radio0
ip address 192.168.90.129 255.255.255.128
ip flow ingress
ip flow egress
ip pim sparse-dense-mode
ip nat inside
ip virtual-reassembly in
zone-member security PRIVATE
ip igmp join-group 239.255.255.250
ip igmp version 3
no logging event link-status
!
encryption mode ciphers aes-ccm
!
ssid yourhouse
!
speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
channel 2462
station-role root access-point
world-mode dot11d country NO both
ntp broadcast client
ntp broadcast
service-policy input mark_qos
service-policy output trust_qos


Thanks,

Oyvind
 
can you do anything when connected to this SSID? meaning can you access the Internet?

 
Hi, yes can connect. But can't see other devices.
 
Can it be something wrong with the ARP configuration wireless. The host's cant resolve each other ? The cabled network configured with SVI can share files.
 
After setting up WLAN with BVI and VLAN it works.
 
Poor WLAN network performance and drops after setup with BVI and SVI, any ideas ?
 
The reason for drop, poor performance was misconfiguration of zone based firewall. It must be applied to BVI and SVI, not the dot11 interface.
 
Problems after some hours. Removed ZBFW from SVI, applied it to only BVI. So far so good.
 
Hi, still problems with the wireless connection. CRC and Output errors occurs.

sh int dot11 0
Dot11Radio0 is up, line protocol is up
Hardware is 802.11G Radio, address is 001b.d4d2.2270 (bia 001b.d4d2.2270)
MTU 1500 bytes, BW 54000 Kbit/sec, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/17297/0 (size/max/drops/flushes); Total output drops: 3183
Queueing strategy: fifo
Output queue: 0/30 (size/max)
5 minute input rate 1000 bits/sec, 1 packets/sec
5 minute output rate 1000 bits/sec, 1 packets/sec
120892 packets input, 14226752 bytes, 0 no buffer
Received 1731334 broadcasts (0 IP multicasts)
0 runts, 0 giants, 46 throttles
108 input errors, 8449 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
167386 packets output, 130970301 bytes, 0 underruns
1535 output errors, 0 collisions, 2 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out


bridge irb
bridge 11 protocol ieee
bridge 11 route ip

dot11 ssid yourhouse
vlan 11
authentication open
authentication key-management wpa
guest-mode
wpa-psk ascii 7 xxxxxx

interface Dot11Radio0
no ip address
ip directed-broadcast
!
encryption vlan 11 mode ciphers aes-ccm
!
ssid yourhouse
!
speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root access-point
world-mode dot11d country NO both


interface Dot11Radio0.11
encapsulation dot1Q 11 native
ip directed-broadcast
bridge-group 11
bridge-group 11 subscriber-loop-control
bridge-group 11 spanning-disabled
bridge-group 11 block-unknown-source
no bridge-group 11 source-learning
no bridge-group 11 unicast-flooding

interface BVI11
ip address 192.168.11.1 255.255.255.0
ip nat inside
ip virtual-reassembly in
zone-member security PRIVATE

interface Vlan11
no ip address
no ip route-cache
bridge-group 11
bridge-group 11 spanning-disabled


VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
11 PRIVATE active Fa2, Fa3, Fa4, Fa6, Fa7, Fa8, Fa9

VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
11 enet 100011 1500 - - - - - 0 0


Thanks,

Oyvind
 
This info ?

sh int dot11 0.11
Dot11Radio0.11 is up, line protocol is up
Hardware is 802.11G Radio, address is 001b.d4d2.2270 (bia 001b.d4d2.2270)
MTU 1500 bytes, BW 54000 Kbit/sec, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 11.
ARP type: ARPA, ARP Timeout 04:00:00
Keepalive set (10 sec)
Last clearing of "show interface" counters never
 
Forgot this info :

interface Dot11Radio0.11
encapsulation dot1Q 11 native
ip directed-broadcast
bridge-group 11
bridge-group 11 subscriber-loop-control
bridge-group 11 spanning-disabled
bridge-group 11 block-unknown-source
no bridge-group 11 source-learning
no bridge-group 11 unicast-flooding
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top