Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can't make call from pabx hicom to ipbx cisco

Status
Not open for further replies.

youfo007

Technical User
Nov 4, 2012
50
MA
Hi,

I can't make a call from pabx hicom to ipbx cisco through another pabx


Pabx hicom A to pabx B to ipbx cisco
There are Trunk e1 between A & B and trunk e1 between B & ipbx

Pabx A call pabx B n both directions A to B and B to A

Pabx B call ipbx cisco also in both directions

Ipbx Cisco call pabx A. The problem pabx A can't make a call to ipbx cisco

what are the parameter I have to check on cot & cop & cos


Tanks for all
 
hi,

thank you very much for the effort you make.

for the link is still down.

I found the EMAV2 Protocol on the list supported by the HICOM, but to change the protocol we need permission from the service.

between A and B we have 40 km away.

I also thought about making a direct connection between PBX A and Gateway CISCO.

leave me your email and your Facebook account!

thank you
 
Hi,
Sorry I dont do Facebook - The NSA know enough about me already :)

The best procedure is to bring the Cisco to the HiPath and set them up 'back to back' first before you bring the 40K link into it.

To change the protocol:
deactivate the circuit on the HiPath
CHA-TDCSU:pEN=X-X-X-X,PROTVAR=ECMAV2;

Activate the Circuit.


Do you have a working connection between HiPath A and HiPath B ?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top