SCO "certified" Intek 21 parallel port; Intel D865PERL motherboard. Printer Manager lets me set up printer on /dev/lp3 (lp3 and lp4 available by default) without error. hwconfig shows no entry for the card - apparently not recognized at boot but does have entry for pci base and Acceleraid controller in slot 2.Have tried card fore and aft of Acceleraid card with no change. Have tried forcing interrupt # in sustem bios with no change. Only "clue" is one of the lines describing the raid controller contains "bus=PCI :3 slot=1" when card in in physical slot 2. When trying to send "date" to lp3 get "/dev/lp3: cannot create". Any help appreciated.