We had some power outage in our remote school after the power outage the XNet failed and we cannot access the Mitel via the network we have changed the cabel chnage port on the Cisco. It stayed up for 5 minute after the reboot and then it is gone rechecked the programming replace cable with straight through.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cannot access the Mitel Cxi 3300
- Thread starter tp10m
- Start date
ExCentigram
IS-IT--Management
have you put a console cable on the front of the 3300 (DB9 maintenance port) and looked at what it is doing in the boot cycle? Are all the blinky alarm lights off? First thing you need to make sure is that its actually coming up
A power failure may have caused a fault on the hard drive that is preventing the system from booting ( will people never learn
UPS! ). Either plug directly in the front of the unit or as EXCentigram suggests use a serial cable to see if the system is even up.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
UPS! ). Either plug directly in the front of the unit or as EXCentigram suggests use a serial cable to see if the system is even up.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
- Status
Similar threads
- Locked
- Question