Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can I Connect Multiple SIP Trunks to Avaya IPO 500 v2 Appliance

Status
Not open for further replies.

Irshad78

IS-IT--Management
May 16, 2016
110
SA
I have a current Setup with Avaya IPO 500 V2 with SIP Trunk Primary and Backup Configured with same provider on a Cisco Router doing simple static route and Static NAT. During failover I usually change NAT statement with backup provider and everything works perfect as shown in below pic.

pic_1_a4xfr2.png



Now we are planning to procure one more SIP Trunk with different provider along with Cisco Voice Gateway acting as CUBE, now I would like to know how I can connect this SIP trunk to Avaya IPO. As shown in below pic.

pic2_p830qc.png


Team, please I appreciate your support.
 
My knowledge is only entry level/basic but I've had multiple SIP trunks connected on my IPO 500V2, two different providers and provided you have the licensing for the channels/usage I can't see why you couldn't do it?

I'm back down to one SIP provider so only one trunk configured now but it was working fine...


Thanks, Tim
Adelaide, Australia
 
Yes is the short answer. I have multiple service providers using different SIP trunks in my IP Office units, plus a separate SIP trunk in each one connecting them to a 3cx instance for other services.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top