Ccastillo2310
Programmer
Hi!
I have a CallPilot 100 installed in a 3x8 DR 5.1, only for pruposses of test.
At first time the CallPilot works fine, but after 2 or 12 hours its freeze......LED's no blink, ping to the IP is OK, but I can't admin.
When disconnect the CallPilot, and restart, in the serial port appears the message "TCM out of sync" "If you change the KSU reset the CallPilot" and reboot.
When resseting the CallPilot, works fine again......but again the same problem!!!!
Any have ideas?????
Carlos.
Lima, Perú.
I have a CallPilot 100 installed in a 3x8 DR 5.1, only for pruposses of test.
At first time the CallPilot works fine, but after 2 or 12 hours its freeze......LED's no blink, ping to the IP is OK, but I can't admin.
When disconnect the CallPilot, and restart, in the serial port appears the message "TCM out of sync" "If you change the KSU reset the CallPilot" and reboot.
When resseting the CallPilot, works fine again......but again the same problem!!!!
Any have ideas?????
Carlos.
Lima, Perú.