Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Call fowarding to outside number rings then busy signal

Status
Not open for further replies.

Armstrong2012

Technical User
Jan 20, 2012
43
US
I have a number, 65878 that forwards to an outside line that happens to be a fax line. When I call the number it forwards like it should but as soon as the fax tone starts I get a busy signal. I have the prefix in the ars table with the correct rout pattern. What am I doing wrong? For privacy reasons I've replaced the calling number with xxx in the list trace.


time data

09:41:54 Calling party trunk-group 501 member 2 cid 0x477
09:41:54 Calling Number & Name xxx-xxx-xxxx NO-CPName
09:41:54 call-forwarding
09:41:54 term station 65878 cid 0x477
09:41:54 call-forwarding 9262
09:41:54 term trunk-group 501 cid 0x477
09:41:54 dial 9262xxxx route:HNPA|ARS
09:41:54 route-pattern 52 preference 1 cid 0x477
09:41:54 seize trunk-group 501 member 19 cid 0x477
09:41:54 Setup digits 262xxxx
09:41:54 Calling Number & Name xxx-xxx-xxxx NO-CPName
09:41:55 Proceed trunk-group 501 member 19 cid 0x477
09:42:00 no answer trunk-group 501 cid 0x477
09:42:00 coverage-path 48 point 1 cid 0x477
09:42:03 active trunk-group 501 member 19 cid 0x477

09:42:17 snd RRJ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:20 rcv GRQ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:20 snd GCF endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:20 rcv RRQ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:20 denial event 1927: IP RRJ-Invld station type endpt 10.5.0.3 data0:0xc
09:42:20 snd RRJ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:23 rcv GRQ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:23 snd GCF endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:23 rcv RRQ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:23 denial event 1927: IP RRJ-Invld station type endpt 10.5.0.3 data0:0xc
09:42:23 snd RRJ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:26 rcv GRQ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:26 snd GCF endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:26 rcv RRQ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
09:42:26 denial event 1927: IP RRJ-Invld station type endpt 10.5.0.3 data0:0xc
09:42:26 snd RRJ endpt 10.5.0.3:16002 switch 10.253.196.18:1719 ext 65878
 
What happens when you dial the outside fax line number directly? Does it also busy out? Can you try it from a Cell phone, does it do the same thing?
 
Your denial event translates to this

Registration rejected because of invalid
set type or no Remote Office assignment
on the station form.

You could look at the denial events and post the cause value to see if that can be interpreted further.

APSS (SME)
ACSS (SME)
ACIS (UC)
 
It also sounds like there are two rings going on at the same time.
 
ip office ??? . right ok back to basics can you plug a normal phone(or test butt) where the fax is and dial the virtual station and take the call normally?

APSS (SME)
ACSS (SME)
ACIS (UC)
 
I said IP Office b/c when I searched for "invalid set type" or "no Remote Office assignment" all that came up was stuff regarding IP Office.
 
ok right what i meant was , type display events , you can then filter down to denial and get cause codes that can be interpreted from the communication manager denial events document. But can you complete the process in my first post.?

APSS (SME)
ACSS (SME)
ACIS (UC)
 
I can't really do some of your troubleshooting steps because I am not at that location. I can however dial the fax from my cell and it work fine.

Here is the event report:




EVENTS REPORT

Event Event Event Event First Last Evnt

Type Description Data 1 Data 2 Occur Occur Cnt

1927 IP RRJ-Invld station type 86BC A050003 06/17/15:42 08/16/09:53 255
 
I have seen this before with virtual station, make it a x ported station with coverage page going to the dest and see if that works

acss sme acis sme acss cm 5.2.1 acss cm and cmm acss aura messaging.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top