Whenever I try to run the setup wizard in VFP6, I get all the way to the end where it is building the cab files and it says there was an error building cab files, error code: 3. Am I forgetting a step or something?
I get this all the time. Make sure your project and all associated files are closed - the best way is from the command box, just type CLOSE ALL. If you still get the error, try exiting and re-entering VFP after that. There's a Microsoft report in their KB about it - it's kind of a pain.<br>
<br>
SK
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.