Building a IP-SEC VPN using the IPO R 9.0.3 2

[TISTech1]

I noticed that there is a IP-SEC VPN under the Tunnel section in the R9 IPO. Is this just used to connect a IPO to a VPN or can I create a VPN using the IPO. If so, is there any documentation on it?

Thanks!

Thanks!

I Reject Your Reality And Substitute My Own.

APSS , ACIS , & ACSS – SME

 

[intrigrant]

You need a licence ( 182301 ) and this document

 

[amriddle01]

But it sucks, so don't bother

 

[intrigrant]

He didn't ask that did he?
I have good and bad experiences with it, it all depends on the internet connection and load of the IPO processor.
Since the introduction of the IpSec feature both have increased a lot since the past so I expect no problems on a IPO 500v2

 

[mattKnight]

Encryption / decryption is very processor intensive. I'd try to use a box that is optimised for that (firewall/router) than increase the load by an unknown amount on my call processor.

Right tool for the job rather than compromise on a single one

Take Care

Matt
I have always wished that my computer would be as easy to use as my telephone.
My wish has come true. I no longer know how to use my telephone.

 

[TISTech1]

Thanks guys,

I was more curious than anything. We do occasionally have a customer that might want to hang a single VPN phone off their system. I appreciate the warning.

Thanks!

I Reject Your Reality And Substitute My Own.

APSS , ACIS , & ACSS – SME

 

[tlpeter]

You cannot use the build in VPN of the IPO for VPN phones.

BAZINGA!

I'm not insane, my mother had me tested!

 

[TISTech1]

not even for one 9608 phone?

Thanks!

I Reject Your Reality And Substitute My Own.

APSS , ACIS , & ACSS – SME

 

[tlpeter]

No you can't.

BAZINGA!

I'm not insane, my mother had me tested!