Blocking all outgoing calls

[RSmithwvsf]

i have an option 11c system. i need to setup a block for an ext so that only incomeing calls are allowed what options under class of service should i change?

 

[bigindian65]

lower the ncos to below your route frl, try 1. or try FR2

Mato' Was'aka

 

[telecomPA]

or match the TGAR on the set w/the TARG on the routes. when these 2 match, the call is blocked.

although FR2 is much easier.......

 

[hawks]

FR2 stops in and outbound calls

 

[bigindian65]

FR1?

Mato' Was'aka

 

[bigindian65]

targ/tgar isn't going to fly either unless tgar is set to yes in the esn data block.

Mato' Was'aka

 

[tnphoneman]

Normally NCOS of 0 is set up for Onswitch calls only.

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[tnphoneman]

Clarify the previous post. It should be set up for on switch calls only with the exception of 911 or 9911 calls. You do not want to block those.

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[RSmithwvsf]

need to block all out going calls even on switch exspet 911

 

[911guru]

If you have ESA properly configured with 911 as the ESDN and 9-911 as an SPN that points to an RLI that is LTERM = YES, then 911 will work under any scenario.

If you do not have ESA configured, you could probably do something, but I would activate ESA and do it the right way.

There is a way to block 911 from a set with ESA using Pretranslation, but I would recommend that if you did need to do that, you get a waiver from the PSAP.

911Guru

http://pbx-e911.com

E911 FAQs are located at:

http://www.tek-tips.com/faq.cfm?pid=798&handle=911guru

 

[RSmithwvsf]

i may be miss stateing what i am tryinng to do i want to stop all out goinng call other then 911 this would include on switch calls lolcal calls and ld call. i want to leave the ext in question with the ability to recive calls

 

[guycable2]

remove the dialpad and program a hot dial button for 911.

 

[tnphoneman]

Can't stop internal calls within the switch.

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[bigindian65]

stop mixing HR with Technology. There is no happy medium.

Mato' Was'aka

 

[MagnaRGP]

Big Indian is right. You could do a pretranslation on all digits to a VM thrudial service which has a fully restricted RPL and allow only 9 for the outside lines.

then, when your NCOS is 0, no outoing calls. ESA will handle the 911.

A lot of work for a simple HR issue. Easier to remove the dialpad or buy a phone without.