BCM450, how to: DSM32+?

[Warrenator]

Hello,

I have a BCM450 with DSM32+ installed, this is giving power to extensions which are 'sort of' booting phones up.
They get to the stage where you would expect text on screen, dial tone etc and all it is doing it beeping when buttons are pressed (screen without data, just power to LED). All dip switches are on, and the system can be accessed via IP as you would expect normally.

Any suggestions?

 

[pccal]

Go into resources & look at how the Bus for that card is provisioned . The are numbered i,2.3.& 4 starting with 1 at the bottom. Make sure that it is provisioned for a 32 card. If it is provisioned properly it is probably a bad card.

 

[Warrenator]

Main MBM 1 | DSM32/DSM32+ MBM | All On | N/A | N/A | 221 | 252 | N/A

Mean anything to you?