OmniS3Tech
Technical User
Hi,
I've have a problem, with a BC9 Site,where the Last Digit is missing on the CLI, when DDI Calls are Transfered to the Site Via Q-Sig Link
The setup is as follows Site 'A' has DDI number to the Operator over DPNSS from an AXE,this is Linked to Site 'B' over a Q-SIG link.
Site 'B' has a user with a nice digi phone. The Q-sig link and another DDI DASS Link,
All calls from the DASS link show the Last 10 Digits of the CLI e.g. if the number was 01234 123456 shows 1234 123456, which is Fine.
But DDI Calls Via Site 'A's Operator transfered to Site 'B' Show 0123412345, missing off the last digit on the phones display.
An analzer on the Q-Sig Link shows the full CLI being shown.
Any Ideas? any patches?
I do rememder a similar problem with DPNSS but I believe these were fixed with patch S81326 which I have fitted
cheers OmniS3Tech
I've have a problem, with a BC9 Site,where the Last Digit is missing on the CLI, when DDI Calls are Transfered to the Site Via Q-Sig Link
The setup is as follows Site 'A' has DDI number to the Operator over DPNSS from an AXE,this is Linked to Site 'B' over a Q-SIG link.
Site 'B' has a user with a nice digi phone. The Q-sig link and another DDI DASS Link,
All calls from the DASS link show the Last 10 Digits of the CLI e.g. if the number was 01234 123456 shows 1234 123456, which is Fine.
But DDI Calls Via Site 'A's Operator transfered to Site 'B' Show 0123412345, missing off the last digit on the phones display.
An analzer on the Q-Sig Link shows the full CLI being shown.
Any Ideas? any patches?
I do rememder a similar problem with DPNSS but I believe these were fixed with patch S81326 which I have fitted
cheers OmniS3Tech