jdaley1980
Technical User
I have an Avaya IPO v2 with (1) combo card and (6) Phone 30 Modules. The system is running with software version 7.0 (31). Right now Phone 30 in expansion slot #2/3/4 are all up and running good. Port #1/5/6 are all flashing green. I've tried downgrading to version 6.0 (8) and back up to 7.0(31). I do have an upgrade licesnse to R7. If I disconnect ports #1/5/6 from the expansion port and reconnect the Phone 30 goes from flashing green to no light for about 3 seconds then starts flashing green again. I've used 5 different Phone 30's and they all react the same. I've also used 3 different Control Units and 2 different SD cards with the same results.
When I look at Manager under Control Unit this is what I see.
Device: 6 Analog Pots 30V Version: 8.0(8)
Device: 7 Analog Pots 30V Version: 9.0(31)
Device: 8 Analog Pots 30V Version: 9.0(31)
Device: 9 Analog Pots 30V Version: 9.0(31)
Device: 10 Analog Pots 30V Version: 9.0(31)
Device: 11 Analog Pots 30V Version: 8.0(8)
Device: 13 Analog Pots 30V Version: 9.0(31)
Does anyone have any suggestions?
When I look at Manager under Control Unit this is what I see.
Device: 6 Analog Pots 30V Version: 8.0(8)
Device: 7 Analog Pots 30V Version: 9.0(31)
Device: 8 Analog Pots 30V Version: 9.0(31)
Device: 9 Analog Pots 30V Version: 9.0(31)
Device: 10 Analog Pots 30V Version: 9.0(31)
Device: 11 Analog Pots 30V Version: 8.0(8)
Device: 13 Analog Pots 30V Version: 9.0(31)
Does anyone have any suggestions?