I followed this guide below to connect an Avaya IPO to BCM50, I have it working at other location that is R8.1. I checked the SIP trunks and they say "out of service", instead of in server. Re-created trunks and disabled/re-enabled them. I have 8 licenses which i see in the system status but the "Administered channels" are 0, which is wrong. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Avaya IPO 9.1 to BCM50 R6 SIP Trunk
- Thread starter bbaits25
- Start date
amriddle01
Programmer
Impossible to say without specifics, have you compared the configs side by side , including IP routes and URIs etc ?
- Thread starter
- #3
I got it. I left the SIP config default with VoIP silence suppression and re-invite ticked for the line compared to my other config on the 8.1 this one is 9.1. After i did that the lines came up idle and was able to interdial both ways! thanks for the help!
- Status
Similar threads
- Locked
- Question