Avaya IPO 500 V9, can it network with Hipath3800 on QSIG, ? Settings, Please

[ashutosh2501]

Dear Joe,
We are having a peculiar problem while networking Avaya IPO 500 Version 9 with Hipath 3800 V8 over Qsig.

There are 2 nos. Hipath 3800 linked with each other on Cornet over PRI
There is one PRI incoming trunk at each Hipath.

Now we have installed 3 nos. IPO500 Version 9 and presently linked over Gateways to Siemens.

We have connected IPO to Siemens over Qsig.

All calls from Avaya IPO to siemens go well for ring, OFD and speech, however

calls from Siemens land at desired extension, and in speech mode gets disconnected with 5-6 seconds.
we put trace on avaya, which indicates, a call disconnect signal comes from Siemens.

Can you suggest the remedy, Please?

 

[intrigrant]

It is the Siemens disconnecting the call so dig into the Siemens, on AVAYA side there is nothing which can be changed.

 

[ashutosh2501]

dear intrigrant,
if you could help more... naturally since the disconnect signal is coming from Siemens, we have to effect changes there, but what parameter could cause it to send a disconnect signal to a established call...

 

[intrigrant]

I am not familiar with recent Siemens systems, the last systems I installed/maintained are the larger Hicom systems.
I think it has to do with not recognizing the connect signal cpoming from the Avaya.
You better go here as there are the Siemens guys drop their issues.

 

[ashutosh2501]

No One can help me out on this? No one has ever come across this issue or none has ever done this integration?

 

[amriddle01]

You're asking about Siemens issues in an Avaya forum, you're unlikely to find the answers here