Avaya 3920 repeater registation failure

[dculver]

If you follow the directions to manually register multiple repeaters to a base the proceedure fails at step 5 and repeaters fail to register.
To register a repeater manually, perform the following steps:
1 Plug the AC adapter cord into the AC adapter input jack on the repeater.
2 Plug the AC adapter into a standard 120VAC wall outlet near the base unit for 1 to 5 seconds and then disconnect it. (The repeater must be near the base unit.)
3 Plug the AC adapter into the wall outlet again. The LED on the repeater flashes slowly, indicating that the repeater is in registration mode.
4 Set the base of the Avaya 3920 Wireless Telephone into registration mode by pressing and holding the registration button on the base for 3 seconds. The indicator on the base flashes quickly with no interruptions.
5 Using the handset, press the TALK key to go offhook. The LED stops flashing.
6 Use the handset's number pad to assign a repeater number. Press a number between 2 and 7. Each repeater number can only be used once per base. (These numbers are independent of any handset extension numbers.) When the repeater has accepted the assignment, the LED flashes a corresponding number of times.
7 To confirm the registration, press the STAR key and then the TALK key. The LED goes off for 2 seconds, flashes for a brief moment, and then remains on and steady. The repeater is now registered to this base station.

Any suggestions short of contacting Avaya?

 

[HyTech]

Repeat process. over and over. Not very good advice, but it seems to be the only thing that works.

 

[gonzalez]

dculver,

Did you ever resolve this problem. I am experiencing similair problems but my set up fails at step 6.