Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

AUD032 1

Status
Not open for further replies.

nathanfaatz

Technical User
Sep 4, 2009
38
US
Im trying to log into an option 81c and all that comes up is this AUDO32 Message. Can anyone help me get through this? There are no calls going through the system so I tried a manual reset and the same thing happned. I could see it booting and when it was done this message came up and would not let me talk to the switch at all!!
 
Solutions:
1. You're not using a null modem cable to the terminal.
2. Since you can "see" switch information, you still might be at E,7,1 for speed settings.
3. You're login procedure is wrong.
Have fun...

DocVic
Dedicated to Nortel Products till the end.
Need help? Call Me Now!
 
1.- The cable is straight trough but has a null modem adaptor.

2.- My settings are N,8,1


What would you suggest?
 
Depending on the software release (if it's old...), try using caps when logging in.

DocVic
Dedicated to Nortel Products till the end.
Need help? Call Me Now!
 

could be something more Serious

below are some possibilities


Fact:
Core

Symptom:
One-way speech on one network group
AUD032

Change:
Added new network group

Cause:
The IGS-IGM cables were rolled in grp 4 shf 1.



Problem Resolution

Fix:
Connect the IGS- IGM cables properly.

For more information, see the NTP: Cabling Common Equipment
Meridian 1
System installation procedures
Document Number: 553-3001-210
Document Release: Standard 15.00
Date: April 2000



Fact:
Core
25.30
Option 81C


Symptom:
AUD032 errors
AUD032
Unable to switch CPUs.
BSD103 11 0 7 66 67
BSD103 11 1 3 66




Problem Resolution

Fix:
Run a LD 45 test.
Replace a IGS card.


Crosstalk with CallPilot access ports. AUD032 is produced.

Products Affected:
Communication Server 1000
CS1K
Symposium Call Center Server
SCCS
CallPilot
CallPilot access ports

Cause of Problem:
PEP MPLR19939 is defective.
Problem Resolution
Remove PEP MPLR19939

 
AUD032 0000E223 0000000E 0000000E

AUD032 0000E22F 0000000E 0000000E

AUD032 0000E23C 0000000E 0000000E

AUD032 0000E223 0000000E 0000000E

AUD032 0000E22F 0000000E 0000000E

AUD032 0000E230 0000000E 0000000E

AUD032 0000E23D 0000000E 0000000E

AUD032 0000E263 0000000E 0000000E

AUD032 0000E26F 0000000E 0000000E

AUD032 0000E27B 0000000E 0000000E


This is all that showes up! It wont let me even try to login. This pops up about every 20 mins. or so. The Rls. is 3.0 I am connected with a null modem cable to J25. Serial settings are N,8,1.
 
Do you need a null modem for J25? Try the same connection on J23. You need a null modem for one but not the other I think

Thanks,

Buddy
 
Well im able to see the error messages so that tells me that It is cabled correctly or I wouldnt see anything rite?
 
You should be only be connected to your SDI paddleboard, unless you are upgrading or updating to the Core.

DocVic
Dedicated to Nortel Products till the end.
Need help? Call Me Now!
 
correct Cable most likely correct

Besides - problably working before and you made no changes.

AUD0032
Junctor audit indicates a timeslot is idle but the junctor memory is
marked busy. Time slot is marked idle. Junctor address and memory
contents are output.

and INI might correct this - give it a shot later when you have a service window. INI may also correct TTY issue.

If you need to talk to switch before you can try an INI, Try a different TTY or if large switch try core port.
 
So I swapped CP cards and did a sys load and I am now able to communicate with the switch but I am still getting the AUD0032 errors.
 
If you have a ran card try disabling that to see if the aud32 errors clear. What software level are you on? I'm running 5.5 and had the aud 32 errors and there were patchs to correct the issue.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top