Hi all,
I have done this before and it has worked. I am now on another system and it is not working. I shall explain.
I am working on an IPO v2 7.0.27 and I am creating a new routing table (51) that will restrict all toll calls. In that table I am adding short codes like:
Code: 1N
Telephone number: (nothing)
Feature: Barred
Line Group ID: 0
Then in the User (201) programming I am going to the short codes tab and I entered:
Code: 9N
Feature: Dial
Telephone number: N
Line Group ID: 51 (the restricted ARS table)
So user 201 should not be able to dial 9 + any phone number beginning with 1.
BUT user 201 can dial 9 and a long distance phone number beginning with 1 just fine. It goes through. I do not know what I am doing wrong here.
I built a restricted table (51) and barred 1N and then did a user short code that pushed any 9N through the 51 table. Why is it not restricting the 1+ numbers?
Thank you in advance
MRoberts
I have done this before and it has worked. I am now on another system and it is not working. I shall explain.
I am working on an IPO v2 7.0.27 and I am creating a new routing table (51) that will restrict all toll calls. In that table I am adding short codes like:
Code: 1N
Telephone number: (nothing)
Feature: Barred
Line Group ID: 0
Then in the User (201) programming I am going to the short codes tab and I entered:
Code: 9N
Feature: Dial
Telephone number: N
Line Group ID: 51 (the restricted ARS table)
So user 201 should not be able to dial 9 + any phone number beginning with 1.
BUT user 201 can dial 9 and a long distance phone number beginning with 1 just fine. It goes through. I do not know what I am doing wrong here.
I built a restricted table (51) and barred 1N and then did a user short code that pushed any 9N through the 51 table. Why is it not restricting the 1+ numbers?
Thank you in advance
MRoberts