I am getting an error message when I refresh. It says "Could not read parms." When I click OK, the system comes up and operates normally. What should be done to correct this issue? A link to a screenshot has been posted below.
The program having the issue is dbup3, which I didn't think ran when doing a refresh, but I could see why it might.
Maybe try running a database upgrade on both newdata and data. Utilities > Database Upgrade. Take the defaults and hit run. Then do it again, but change "NEWDATA" to "DATA" in both lines. Refresh.
If that doesn't work, post here and I will look some more. There was nothing overt that I found on a first glance through the documentation.
The database upgrade for NEWDATA worked, but the upgrade for DATA did not. I am still occasionally seeing this error message; it's not constant, just comes up once in a while.
When you say it didn't work for Data, what do you mean? What happened when you tried? Any error messages?
Doing the dbup on Data is really more of an extra thorough step. Doing it on Newdata and refreshing should take care of any issues, so this is not making sense right now.
Can you also provide a snippet of the master terminal debout at the time of the FOH error occurrence? Give about 30 seconds worth of information from before and after the "Terminal Up" message.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.