Any job I start goes directly into a schedule state. I checked the services and the one that starts the jobs will not be started. I will start the service and the scheduled job will start but will freeze after 50 seconds. Also when I try to select the C: drive in the Backup tab it is giving me a returned Null or it may not display anything with a message "not connected to server hit F5 to retry" or if it does show the C: it will not show anything that is in the folders. It acts like it cannot see the c: drive. And when I go to the restore tab there are no volumes listed. The only thing it is letting me do at this point is inventory a tape. It will not catalog any tapes or do backups. I have tried closing the application and restarting it. It will come up after the 3rd time trying. It will usually bring up the flash screen and then close out. I will then go into services and start the one that is not started and reopen the application and this time it will come up. What am I overlooking? This is the first problem I have had with this software on this server since we installed it over a year ago.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
All Jobs Go To A Scheduled State
- Thread starter Margarie
- Start date
- Thread starter
- #3
PiNGceNTraL
Instructor
I had to call Veritas on this one! Make sure that you Disable these services; Remote Storage needs to be disbled and if you have a Robotic Libarary the ADIC Door Monitor will be disabled too. This should fix it.
- Thread starter
- #5
- Thread starter
- #7
- Status
Similar threads
- Locked
- Question