Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

All Ciruits Buzy on BCM450 PRI

Status
Not open for further replies.

nooop

Technical User
May 12, 2007
311
US
I keep getting inbound complaints of "all circuits busy". I have had Telco test, and test, and test for weeks. I replaced the DTM card, and checked settings over and over. It seams that the system will not grab channels properly. Is it possible that the BCM is causing this issue? I am about to put a ticket in with Nortel, but I feel it is a telco issue still.
 
And you have seen this while on the monitor? Are all lines tied up , what is the PRI set up as?
 
Noop

is is possible they are getting this on a DID call to a user who is already on a call ?

check the target line if so.

But it sounds like a telco issue.

It's only dialtone-VZ
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top