Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ALI-IV-PCI

Status
Not open for further replies.

Vilse

Technical User
Feb 13, 2011
46
SE
Hello!

Where can i find inforamtion about ALI-IV-PCI? this card is used in Nice Digital Logger.
In the back side of this card there is three diodes (ACT, DSP and TERM) and i want to know what these diodes means.

I have tried to search the web but can´t find anything.
Please help=)

/DN
 
Thanks for reply but i have been in there an looked at "Nice Hardware Diagnostic Tools Webinar Presenation" but i can not find anything about the card and the diodes.
 
act -activity
dsp - 1 dsp per 8 channel
term - termination depends whether if card is terminated or not as per high density logger hardware manual
 
LED Description
Board Active Lights up when board is active
DSP Lights up when DSP has no error
Termination Lights up when termination is activated in the board
 
Thanks but when i try to follow the link you gave me and logon to extranice i got this error message: "The website declined to show this webpage" =(
I can logon to Extranice if i don´t follow you link, why?

What key word did you use to find the document?
 
sorry cannot help you there. i searched on ali iv in extranice and found this document easily
 
Ok, i have tried on two differnt comupters but i got the same eror message when i try to logon=(.

I have three Ali-iv-pci total of 72 channels.

The first board that hanldes channels 1-24 the status is like this: ACT is flashing, DSP and TERM is constant green.

The second board that handles channels 25-48: ACT is flashing, DSP ic constant green and TERM is don´t light up at all.

The third board that handles channels 49-72: none of the three status diodes light up at all.

I have activity on channels 1 and 25.

Is it something wrong with board 2 and three? do you know how i can activate the Termination?

 
ok how many channel licenses do you have. do you see channel status in monitor/channel monitor if perform?

if its 8.9 have you enabled the channels?

 
are the cards also connected via h100 or mvip cable if old version of NICE
 
It is a ALI24 cable, this cable is used for an older verson of NiceLog that use ADIF24 card.
I have both an older version and a "newer" version of nicelog, the older version use ADIF24 card as above and the "newer" version use ALI 4 card.

Maybe i can´t connect ALI24 cable to ALI 4 card?
But i can see there is activity on channel 1 (channel one is board 1) and channel 25 (channel 25 is on board 2) on Nice Application 8.9 that i have installed in my workstation, but the boards diods act different?

I checked the config files i used when i installed "Nice perform Voice Logger SP3", then i saw that i used fonfig files for 48 channels.
I tried to reinstall everything but with config files for 72 channels. Now i can see that the third board is active also.

But i still can see that board one have the "Term" diod lighted upp but the "Term" diode on the other two boards don´t lights up at all.

Can i light up the termination somehow or should it be not lighted?

I use Nice application 8.9 with sp4 on my workstataion.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top