I've got an old ACS R6 system that we replaced years ago with the newer Partner ACS. I wanted to get this old system working again. It is the 5-slot carrier with the ACS card in the center slot and a 206EC card to the left of the ACS. When I power the system up, the green light comes on on both cards, but after a few seconds, the light on the 206EC card goes out (the light on the ACS stays on). If I plug a system display phone into any of the jacks on the 206, I get nothing (no display). If I plug the phone into the ACS card, the phone works. If I move the 206 card to another slot, same thing, the light comes on then goes out after a few seconds. Is the 206 card bad? This was working when we took it out of service.
I also have a voice messaging PC card that was part of this system. If I plug it into either slot on the ACS, the system does not recognize it (intercom-777 gives me a busy signal and feature-59 tells me to insert a valid card). This card was also working, how could it go bad?
I also have a voice messaging PC card that was part of this system. If I plug it into either slot on the ACS, the system does not recognize it (intercom-777 gives me a busy signal and feature-59 tells me to insert a valid card). This card was also working, how could it go bad?