Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Access Denied when dialing 1800

Status
Not open for further replies.

dan737

Technical User
Oct 21, 2014
184
US
Access denied when dialing 1800, not sure if problem is on the Mitel or Telco,

Any suggestions?

Thanks
 
If your display is saying access denied then the issue is internal.

Verify your ARS

**********************************************
What's most important is that you realise ... There is no spoon.
 
Yes the display, what should I look for on the ARS

Thanks
 
start with digits dialled , if its route check the cor of the route , if its list check the cor of all routes

check teh cor of the user account and make sure that the trunk cor doesnt have the user cor listed in cor groups

If I never did anything I'd never done before , I'd never do anything.....

 
Access denied refears that the system is applaing the COR that you have programm to this kind of dial (1 800 + digit string) in ARS of cours that is related to the routes, and the routes have a COR in this case is this COR that you have assignated to this kind of ARS string (1800 +) the reason you recived Access denied try to use another route with the same médium route but diferen COR (open)!!!
 
COR Can be difficult to understand.
The way i learned it is to remember the saying "If you are in, You're out"

Routes have "COR Groups"
User's have "COR's"

Check the user's "COR" lets say it's "5"

The trick is to follow the ARS Digits dialed, To find out what "Route" the call would take, The route will have a "COR Group" applied to it. I'll use "COR Group 10" for my example.

Once you have the COR and the COR Group, this is where the "If you are in, You're out" part comes in.
Check under System Properties -> System Feature Settings -> Class of Restriction Groups.

Look at group 10, If group 10 has COR 5 in it, The call is blocked. If 5 is not in the group the call is allowed.
Keep an eye out for ranges

So if group 10 says:
1-10 (COR 5 is in the group) Call Blocked
1,2,4,9-32 (COR 5 is not in the group) Call Allowed.


Hope this explanation helps !
I struggled with COR when i first learned Mitel.
 
@dan737

Might be best to give us some data to work with

In your dialed digits what route is assigned to the 1800 call
In that route what COR Group is assigned
In that COR GROUP, What restricted COR's are entered
From the phone making the call, what COR is assigned to the phone

Compare that to local calling and you will likely be able to find the problem.

**********************************************
What's most important is that you realise ... There is no spoon.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top