Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

3900 Phase 2 sets

Status
Not open for further replies.

hawks

IS-IT--Management
Oct 9, 2002
5,869
US
Can a phase 2 set be upgraded to a phase 3 set? I know I can take a 3 down to 2 compatibility with lower software then back up to 3 with RLS 25.40 or higher. But someone said that you could purchase a phase 2 set and upgrade it to a 3 is this true. If this is true then why spend the money on a phase 3?
 
No hits at all........
 
Firmware or Fuctionality either one.
 
So I can take a 2 to a 3. Do I just do a Flash Download from the system or is there something else involved. Also when I ID the phone will it now show as a Phase 3 phone?
Thanks for the info so far.
 
Yep, you need to get the firware update from your vendor, put it on option **c. Then you can download the firmware to that phone. If i remember you option **c, it has to be rel 25.40.. LD 117 for a inventry of sets and I think it is LD 30 something for the firmware to the phone. If it works you will see the firmware updating on the phone,

Cheers,

Killian
 
Thanks killiank I have 25.40 and a phase 2 that I did that to and when I ID the phone it still says RLS 2 (which may be normal). Then when I look at the NORTEL Phase 3 Product Bulletin it states that Phase 2 will have Phase 2 Compatibility and the Phase 3 will have Phase 3 Compatibility. So that's where I'm lost, do you know what is the differents between Phase 2 & 3? Is it just the Full Duplex Handsfree Mod that goes on 3? Hope I'm making some since.
 
The features on the phone I upgraded went from 11-13 options to 17 options, did you get this?
 
LD 32 has all the firmware command and in LD 97 you can set up an "automated" download, if that is what we are talking about here.
In LD 32 you can do a FSUM ALL to check the version on all phones and FDLS xxxx to download to a specific model of phone, FDLU l s c u for one set. If your going to do a lot of phones, do it during off peak hours!
 
Thanks guys I'll try that, but do you know if the Handsfree Mod will fit in the Phase 2 phones?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top