Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2620 won't boot

Status
Not open for further replies.

HUANGDI

Technical User
Dec 30, 2002
51
US
Hi,

I cannot get to boot. I changed out the bootroom and flash. Any answers out there?

System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
C2600 platform with 65536 Kbytes of main memory
open: file "n" not found
open(): Open Error = -1
loadprog: error - on file open
boot: cannot load "flash:n"
System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
C2600 platform with 65536 Kbytes of main memory
open: file "n" not found
open(): Open Error = -1
loadprog: error - on file open
boot: cannot load "flash:n"
System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.

 
boot: cannot load "flash:n"

This is your problem i think. Is "n" the name of your IOS file? If not, you need to change your boot command to reflect the correct name of your file.
 
The flash contains the IOS...did you replace it with a new one? Did you back up the IOS so you can load it onto the new flash?

Burt
 
did you put a
"boot system flash n"
in the config?

break the boot sequence and you should be in the boot or rommon prompt.. you can then change how it boots..

if your in boot mode you should be able to edit the config as needed.. if in rommmon you should probably change the config register to 0x2142 so bypass your startup and the router will boot an ios image from flash..

this is assuming that you have a valid image on the flash.
 
plshlpme,

Thanks, I believe you are correct, but I have replaced the bootrom and used both a empty flash stick and one from a 2610 with no luck. I cannot get into rmon. Any tricks?
 
you should be able to issue the break command when it is booting...

the break key is also the pause key on yuor keyboard..
depending on your client you may be able to have it send the break command like putty for example its a "special command"

i use shift break or ctrl break
one of the two should kick you out to rommon ..
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top