Upgraded 2007 to 2009. 2007 was installed on a microsoft 2000 server and working fine w 8 workstations. 2009 could not be installed on the server so i installed on xp workstation [3 gigs, dual core, raid 0 hard drive 7200 rpm]; program works great on the server [xp pro]; other worksations [xp pro all amd dual cores] load the database quickley but all show a spike in data transfer about 15 seconds follwoing start of act [without me doing anything in act]; before this spike [for the 1st 15 seconds], i can move around act without any problems or slowness. As soon as the spike happens, act freezes for about 25 seconds [cpu to 100% usage by act] and then everything works great; no problmes jumping around after this delay [or at least so far in my intial trials]; any idea what the spike of data is 15 seconds following starting act even if act is left idle? also, the cpu usage goes to maximum with the spike and drops back to normal afte rhte 25 seconds when act becomes responsive again!
This does not happen when act is run on the server; there is no network spike or increase in cpu;
also, some of the workstations are connected via 100mb and others are on gigabit net and all show the same behaviour [not a transfer of data speed issue].
thnx for any suggestions you may have.
This does not happen when act is run on the server; there is no network spike or increase in cpu;
also, some of the workstations are connected via 100mb and others are on gigabit net and all show the same behaviour [not a transfer of data speed issue].
thnx for any suggestions you may have.