Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

1140 Add on Module

Status
Not open for further replies.

jacksonsmom

IS-IT--Management
Jul 25, 2008
48
CA
Hi,

I am trying to program a 1140set with an add on module and am not having much success. I am programming through Ld 11 and I have KEM3 in the CLS, however, if I stat the phone it says KEM1 responding. When I try to add another DN to the add-on module it gives me a SCH code1366.

Can anyone tell me what I am missing in the programming end of things.

Thanks

Mary (non technical)
 
I tried to use key 12 and I got SCH361 also my add on module is not displaying anything, it is just flickering.
 
If you just have one add-on module on the 1140, then use KEM 1 in the programming, and program keys starting at key 32 and work your way up.
 
Hi again,

I tried changing the CLS to KEM1 and it gives me a sch0341 again.

 
Sorry I meant to say that I am only using one add-on module.
 
Leave CLS alone, at the KEM prompt enter 1 then start programming your key on key 32 up to 53. Key 0-31 is the phone, key 31 to 53 is the first KEM (22 keys per KEM)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top