Search results for query: *

The Control unit is IPO 406V2 and the release is 3.2(55) the disconnect values on the IP Office analog lines have been change from default of 500ms to 750ms to match the local Adtran settings. [Note: An attempt to use the default setting proved to fail and not properly disconnect.] I currently...

I have a problem with a intergrated T1. Where I am handed 12 analog ports off a Adtran that is use the split a T1 circuit for voice and data. I am able to adjust that disconnect values on the analog trunk circuit to allow for a clean disconnect. The problem that I am having is when I forward...

I should mention that we are working on a IPO 403 that was just recently upgraded from 3.0(44) to 3.1(65_8901)

I have a situation where we are using a Adtran CSU/ACE and the Teleco is stating that the problem appear to be with the vendor equipment ie Avaya IP Office. When calls come into the IPO switch they appear come in and out over the backup analog lines. We never see anyting hit the sys monitor...

Intrigrant, Thanks I will give this a try, it definitely a step in the right direction.

I am have a problem with a configuration to support failover between a PRI and analog backups. In a failed scenario inbound calls come in and hit the auto-attendant just fine. The problem is when a IP Office user attempts call our the call drops after about 5 seconds. I have configured least...

I am not sure if your resolve this problem already, but I just solve this very same issue. Accessing Manager under the telephony tab unclick and click the Dail by Name box and reboot the IP OFFICE. Good luck

I had just work through this simular problem and I have able to resolve the problem by making sure the 802.1Q was turned off since trunk was not being supported on the SOH side. I not sure if this will help, but it resolve my issue.