Search results for query: *

I would like to remove a block of numbers from my Option 61c's numbering plan. I know how to veiw them LD 20 or LD 11 ludn. What I want to do is remove a block of 100 numbers 27xx from the PBX so that when I add a DSC in Ld 87 it routes to a PRI. Currently those numbers will go to the...

Thank you to everyone. I found the problem. It was a signaling mismatch between the Cisco and the Nortel box. I set everything to 4ESS on the Cisco Voice Gateway and it fixed the problem. Again. Thank you to everyone for your help! You guys are great

I just installed a PRI tie line between my Nortel 61c and my Cisco Call Manager. I can reach other locations that are connected to my Nortel by 4 digit dialing with the exception of one location. I also am experiencing problems 4 digit dialing to any extension on the PBX with the exception of...

I am getting this error on my PBX. Does anyone know how to fix this. Also receive an esn127 when trying to add a number to the CDN records.

I have the daughter card installed on my Dual PRI/T1 card and am adding the D Channel (5) to Loop 18, the new loop. What should I answer for CTYP (DCHI?) and I have not a clue for DNUM. Any help anyone can provide would be great!

Thank you all for your help! You all have been a great help. Just for my own knowledge. How can you tell that slot 8 on 0/0 is available?

Below is my CEQU thank you! PRT TYPE CEQU CEQU MPED 8D TERM REMO TERD 002 REMD TERQ 003 REMQ SUPL 004 N080 XCT 000 016 TDS * 000 * 016 CONF * 001 * 017 MFSD * 000 * 016 DLOP NUM DCH FRM LCMT YALM TRSH TRK 020 24 ESF B8S FDL 00...

Ok... Makes sense. I'll give it a try. thank you

So do I do a chg to cequ or new in LD 17. I'm assuming it is a chg since I did not see new as a req option. Is this correct?

I need to add a Dual Port PRI/T1 card to my Option 61 then create a trunck group, DCH, route ect... for a new PRI. I'm not possitive where to start. I've read several white papers that say to use LD 17 and add the card in the CEQU/DLOP. If someone could help me get started I believe I can...

I need to change the framing on one of my loops and I am not possitive how to. Can anyone give some assistance? Current framing is D4/AMI/DG2 and I need it to be B8ZS/ESF Please Help!!!

I need some help in changing my Output ANI from 7 digits to 10. Does anyone know how I can accomplish this?

clid table does have it. cdb doesnt appear to have a place to put it. ANI_DATA ANAT 461 ANLD 8444 Am I looking in the wrong place?

I'm not sure. How can I check? Ld 15 doesn't have a prt option for me to check the settings. Is there another way to check this?

Hello all, I have a simular problem in my switch. Option 61C Release 22. I swung PRIs from one provider to another. The problem I am experiencing is a little different. When internal callers make a call outbound what shows up on the receiving end is "Unavailable" and the number. The new...