Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. melask8

    "SCSI PORT Error" Arcserve v9 Win2000 Sony AIT

    Thanks SjrH, I had tried that registry attempt already with tech support at CA and the firmware was current. Basically, I went the "when in doubt rip it out routine". I uninstalled the media changer, SCSI controller and tape drives from device mgr. I then assigned the AIT to the next...
  2. melask8

    "SCSI PORT Error" Arcserve v9 Win2000 Sony AIT

    Our Sony unit decided to eat a tape one night, so they sent us a (exact model)replacement. Since the replacement came we have been caught between Sony/CA/Dell trying to figure out why the backup will no longer run. Lots of finger pointing.... the only change was the tape unit. Arc v9 will...
  3. melask8

    Looking for a good firewall

    We have been very happy with our Watchguard Firebox/SOHO solution. We have a fairly basic design behind the firewall (email/web servers and LAN) and are tunneling VPN and TS. We have not purchased Spamguard but see that it is written up quite often as an excellent add-on product.
  4. melask8

    NAV2004 problems

    I've run into this quite often with Win98 - it just doesn't want to let go! In each case, I have uninstalled NAV (even Symantec Corp. version) manually following the directions offered at their support site. http://www.symantec.com/search/ enter "manual uninstall NAV 98" Run through the...
  5. melask8

    Primary IDE only - How to..

    The Sec IDE has a badly twisted pin that I can not straighten. I have connected only the HD (master) and the system boots fine, it also boot fine from the CD (master). I just made the HD slave and CD master and it seems to boot fine. Perhaps it was bad power connector (I changed the one I was...
  6. melask8

    Primary IDE only - How to..

    My PC has a broken Secondary IDE. I need to connect the CD and hard drive to the Primary IDE. Currently, I have the HDD as master and Cd slave. I have set the BIOS to boot from CD but it won't. This should be doable, right?

Part and Inventory Search

Back
Top