Search results for query: *

I have about 40 APC UPSs that I have to change the syslog settings on and I am trying to script a telnet program to change them all but I have had no luck. I have used netcat for windows before for a homebrew script to use on cisco routers, but netcat doesn't seem to like the emulation on the...

Thanks for you help guys. I believe I have it setup now I just need to see if it works.

What's your configuration register set to?

Could you place a default route with a higher cost than the primary route and point it to the backup interface.

I just purchased a new AIM-ATM-4T1 bundle and I need to configure this for IMA. I have setup IMA on the older NM-4T1-IMA card but I have never worked with this newer card before. Does anyone have any configuration examples using this new card? Any help would be greatly appreciated. One last...

Does anyone know of any good (preferably free) software for viewing netflow stats? Thanks in adavnce.

Great thanks for help lui3.

I would think that your T1 interface IP would change to one of the new ones provided to you how ever your ISP should tell you which one to use as their router will have the another ip on the same subnet as yours. You could then use a public IP on the Ethernet Inferface on the router and have...

From my experience if a router is setup for a frac T1 and you have a full T1 (24 timeslots) then it would not link up. Do you have an internal CSU or an External CSU? Try this link (requires a CCO account) https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl Do a show...

Looks like the 2691 was 3 WICs and a NM port which I believe would support 2WIC, 2WIC 1FE, or 2WIC 2FE. So you could have up to 5 T1s on this setup. Are you using the WIC 1DSU-T1 card or the WIC-1T card? There is also a 4 port or 8 port IMA card that will work in the NM on the cisco 2600...

Yes a 2620 would work fine. Is this 3 T1 lines or is it a frame-relay T1 with 3 pvcs?

Which device is handling DHCP? Do you currently use internal DNS? If so which device handles this?

I have a Cisco 2620 with a four port ethernet card installed and I would like to setup two DHCP pools and assign the Pools to different ethernet interfaces. I have setup DHCP on Cisco routers before only using one scope but I do not know how to setup a specific pool on a defined interface and...