Martin,
Thank you so much for your input and I also want to Thank
Syar2003 and Freestone, I have learnt so much just for the short time I've been on Tek-Tips.
Thanks Martin, I understand now, but couldn't I just buy a better 6 cu fan that is quieter than the Thermaltake Volcano instead? I have to admit it is quite a bit nosier than this older computer I'm on now. This is quite a bit quieter for sure.
Hi,
I plugged the chassis fan in the back to the cha_fan1, then installed a second fan in the lower front. The Settings for the CPU Fan , Power Fan and Chassis Fan Threshold are all set by default at 1200 rpm. I'm still getting the same reading for the CPU which is 4623 but the Setting for CPU...
Freestone, there are 3 wires coming from the case fan Red, Yellow and Black, but I'm still getting 0 from the Power Fan and Chassis Fan and as I was saying in the BIOS it is showing 0 for either one of them also.
I purchased this ATX Case from a small computer business that who was going out of business so there were no papers with it. The power supply however was included with the Case which is 350W but the grill opening is on the side where the power supply wires come out and not on the bottom. I have...
Syar, you see I've been teaching myself and have never went to school or anything as I'm sure you can tell lol :) This is one of the reasons why I'm asking so many ?'s and from all the great answers it seems everyone else must have went to school? or just very very smart.
Yes the 3 Pin...
I did install one case fan on the back of the case not far from the CPU and just connected the wires directly to the PWR Fan one. I can't set the threshold for the chassis below the 1200 as that's the lowest it will go. When I first installed the ASUS PC Probe neither the Power Fan or Chassis...
I just went in the Bios and under Hardware monitor The Chassis Fan and Power Fan Speed is set at 0 RPM I don't see any place to change these settings and did change the RPM in the PC Probe software but I'm still getting the same ticking sound like a clock with the same messages.
Chassis Fan Threshold is set at the default of 1200 rpm. I'm getting clicking noise telling me the Power Fan and Chassis are 0 and the Monitor Summary for both of these the Value is 0 and it's blinking with the words (Power Fan below threshold!!! for both. I'm using Windows ME and I have the AMD...
Since I'm very concerned now about what Paparazi said as written below. I have the manual right here and there is 1 pin missing alright. From the manual though I still don't know which pin is the Black ground and the Red to plug into.
The First 4 pins when laying the case down on the bottom is...
So in other words in the Advanced Chipset It says CPU External Freq (133 mHZ and the Memory Frequency says By SPD resulting Frequency 133 MHZ would be the same?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.