Search results for query: *

I am using the Max TNT and ICRadius with MySQL. I am getting an error in my radius.log. "Error: Acct: Invalid STOP record. [] STOP record but zero session length?" It doesn't allow them to login. Any ideas would be helpful

Here is another snip of what I am getting IFMGR-45: makeRoutesInactive IFMGR-45: make interface inactive request (status 0x3). IFMGR: free interface 45, prof 0 IFMGR: _routMgrDestroyCallback, routeID 1672, cause 0 RADACCT-863:createRadAcct: new session. RADACCT:_getSessEntry: no sess, route=863...

Here is a clip of what I see. Thanks IFMGR: _routMgrDestroyCallback, routeID 498, cause 0 IFF-10: makeIfActive: <kai>, <216.130.232.92/32>. IFF-10: Interface has VRouter name = , ID = 0 IFMGR: no interface found for host kai IFMGR: getInterfaceByIpAddr: addr 216.130.232.92, vRouterID 0...

Accouting is setup correctly. I double checked. Nothing is going to my radius server.

My Max TNT is not logging to my radius server. I usually see logs in /var/log/radacct/*ip*/details. Any ideas?

Cables were tested using a fluke. Passed everything. They are only about 25 feet long.

We provide a customer of ours currently 6 T-1's in a Multilink group using a 3620. We have changed the cabling from the router to the smartjack. We also have successfully tested head to head with the Telco using a TBird. The T-1's currently show CRC errors. The Multilink group does not. We...

Early I wrote a post dealing with a T1. It isn't ISDN. In doing the t1channels command, I get the following output. I am sure that this is the reason why I get dead air when dialing the dial in number. They should be idle. Any help would be great. T1 channels allocated/in-use...

I insisted with the vendor I purchased it from that it wasn't the right memory. They are 100% positive that it is. Is there anything else I can do to check?

I inserted a 32 mb SCANDISK ATA FLash Card. When I do a dircode it doesn't show. When I attempt to format is say error: flash card 2 is not present. The status shows PCMCIA socket 2: card inserted. Any help would be great. Evan

I mean that I don't hear a modem tone and it doesn't ring. I also don't see anything when doing a status. If by chance it does register, it says as a c on the status windows. The T1 card in my TNT is the 8t1-card. I upgrade to eventually get to version 9 to support V.92. I can downgrade to...

I upgrade to Version 8.0-103.0. I had everthing working fine on 7. The TNT isn't picking up when I call the number, I get dead air. The T1 shows up and idle. It's isn't a PRI, it's a switched t1 with inband signaling. Any help would be great. I guess worse case is I go back to Version 7...

I have a route setup in my switch for the ip pool. I started the pool at 1. Where in the tnt do I tell it what the route for the ip pool is? Other then the default gateway.

I am on a different logical subnet. I checked the proxy setting...currently it is off. Maybe I am setting up the pool incorrectly. I also am using the default profiles. Haven't added any

I am setting up a MAX TNT. I have it authentication with the Radius server and assigning an ip from the TNT. I can't get connectivity to the outside. I assume it is a simple as routing the ip pool to the default route but the documentation is limited. Any help would be great!