Upgraded TAOS!!!! Can't connect to modems now

[elhnet2000]

I upgrade to Version 8.0-103.0. I had everthing working fine on 7. The TNT isn't picking up when I call the number, I get dead air. The T1 shows up and idle. It's isn't a PRI, it's a switched t1 with inband signaling. Any help would be great. I guess worse case is I go back to Version 7.

Thanks

 

[MaxPipeline]

When you perform a show commmand, are all your slot cards in UP status? Also when you say you get dead air, do you mean something does answer the call and you hear nothing back? Or do you mean the modem never picks up the call (phone continues to keep ringing)? What slot cards (model numbers) do you have in your TNT? Finally what was the reason you went to 8.0-103.0? The reason I ask about 8.0-103.0 is because according to the release notes, this is for Multivoice (VoIP). If you are using your TNT for dialup network or Internet access then you should be using a non-Multivoice version of TAOS such as 8.0.5.

 

[elhnet2000]

I mean that I don't hear a modem tone and it doesn't ring. I also don't see anything when doing a status. If by chance it does register, it says as a c on the status windows. The T1 card in my TNT is the 8t1-card. I upgrade to eventually get to version 9 to support V.92. I can downgrade to 8.0.5 to see what happens. Thanks for all your help.