Search results for query: *

I suggest it has to do with DirectX... try installing 9.0b. Else it could be a resource conflict (?) Regards

You can also try running the supplied scripts in the program folder and link a schortcut to it on the desktop. scripts are: - optivity_apps (start/stop) (thought also restart, but not sure) - optstatus -fe (output if processes are running) This are "dos" commands, so run optstatus in...

Hi Junwu, Did you guys recently updated the "ios" on the baystacks? That could cause an error, cause the snmp values read from the switch change from time to time.

Hi Mutha, Try following this link: http://www.fel.fujitsu.com/home/drivers.asp?L=en&CID=1 Page contains a tool "FJDT (Fujitsu ATA Diagnostic Tool)" Take care

Hi Usa, Try booting again from the floppy and do the following: - on the command prompt type: FDISK /MBR (this will create a new Master Boot Record) - then do an new sys a: c: If none of the above works, try to backup your files to a different disk and repartition your disk for a clean...

Hi Monkster, Which raid controller are you using? If you are using a Promise card, set the jumper in the back of the drive(s) to CableSelect (CS), look in the HDD manual or on the HDD for the correct position of the jumper. The HDD should be recognised automatically as slave/master. If you...