I installed Partition Magic 8.0. I get the following error message when I try to merge 2 partitions:
Error 626 Operation is to be performed on a hard drive not visible from boot mode. Power Quest recommends the following...
Cause 3: If this error is reported when resizing a partition on a large RAID drive in boot mode, the problem is that the partition is on a slave drive on the RAID controller and is detected as drive 3 in the chain. Drives 0, 1, and 2 are left undetected when the drives post.
Fix 3: Change the affected RAID drive to master so the system can detect it as drive 0.
How do I go about changing the affected RAID drive to master???
Thanks!
Error 626 Operation is to be performed on a hard drive not visible from boot mode. Power Quest recommends the following...
Cause 3: If this error is reported when resizing a partition on a large RAID drive in boot mode, the problem is that the partition is on a slave drive on the RAID controller and is detected as drive 3 in the chain. Drives 0, 1, and 2 are left undetected when the drives post.
Fix 3: Change the affected RAID drive to master so the system can detect it as drive 0.
How do I go about changing the affected RAID drive to master???
Thanks!